Epoxy Primer Black

Epoxy Primer Black

Related Products:

Brenin

Brenin White

Designed to protect masonry surfaces. It creates as barrier so...
Read More
Brenin

Brenin Strawhat Biscuit

Designed to protect masonry surfaces. It creates as barrier so...
Read More
Brenin

Brenin Sage Green

Designed to protect masonry surfaces. It creates as barrier so...
Read More
Brenin

Brenin Sanji Yellow

Designed to protect masonry surfaces. It creates as barrier so...
Read More

Epoxy Primer Black

Hover image to zoom in

General Description

A two-component epoxy-polyamide-based paint is used to provide corrosion resistance to steel. It also gives good adhesion to
various substrates.

Recommended For:

steel, concrete, and wood where resistance to industrial conditions is desired.

 

Application Method

Coverage 20 – 25 sqm per 4 Liters per coat
Color Primer Gray
Topcoat As per request
Finish Primer Flat
Gloss Gloss
Number of components Two (2)
Mixing Ratio (by volume) Resin 3 parts
Catalyst 1 part
Induction Time 15-30 minutes
Pot Life 6-8 Hours

 

Drying Time

To Touch 1 – 2 hour
To Recoat 6 – 8 hours
Method of Application Brush / Roller / Spray
Thin With KINGS Epoxy Thinner
Clean Up With KINGS Lacquer Thinner
Thinning Use as supplied. But if needed to obtain the desired consistency, add not more than 1/4 Liter of KINGS Epoxy Thinner
Number of coats 1 – 2 coats
Packaging Supplied in two separate tin cans
Part A (Resin) Part B (Catalyst) 4 Liters 3 Liters 1 Liter

 

Surface Preparation

Service life span and the service performance of these products are directly related to the degree of surface preparation

Steel

  • The surface must be clean, dry, and free of contamination such as oils, grease, mill scale, or rust.
  • A minimum of hand tool cleaning or power tool cleaning is recommended, however commercial blast cleaning will provide
    improved performance.

Concrete

  • Sweep blast. Remove all contaminants such as dirt and laitance. Acid etched.

Wood

  • Block down. Wipe with a cloth containing solvent.

 

Applications

Stir each component thoroughly before use. Mix to uniform consistency 3 parts of Part A (resin) with 1 part of Part B (Catalyst).
Mixed components should be applied within 6 hours. Surface temperature must be at least 3°C above the dew point to prevent moisture condensation. Note: Ensure protection and proper ventilation if working in contained areas.

1st coat KINGS Epoxy Primer Gray
2nd coat KINGS Epoxy Enamel Topcoat
Final Coat KINGS Epoxy Enamel Topcoat

 

Chemical Resistance

Withstands intermittent splash and spill of aromatic solvents. Resistant to diluted acids and common alkalis and salts.
Consult Bosny Marketing technical representative for certain chemical concentrations and specific services.

Available in different colors: