Brenin White
Designed to protect masonry surfaces. It creates as barrier so...
Related Products:
Hover image to zoom in
General Description
A two-component epoxy-polyamide-based paint is used to provide corrosion resistance to steel. It also gives good adhesion to
various substrates.
Recommended For:
steel, concrete, and wood where resistance to industrial conditions is desired.
Application Method
| Coverage | 20 – 25 sqm per 4 Liters per coat | |
| Color | Primer | Gray |
| Topcoat | As per request | |
| Finish | Primer | Flat |
| Gloss | Gloss | |
| Number of components | Two (2) | |
| Mixing Ratio (by volume) | Resin 3 parts Catalyst 1 part |
|
| Induction Time | 15-30 minutes | |
| Pot Life | 6-8 Hours | |
Drying Time
| To Touch | 1 – 2 hour | |
| To Recoat | 6 – 8 hours | |
| Method of Application | Brush / Roller / Spray | |
| Thin With | KINGS Epoxy Thinner | |
| Clean Up With | KINGS Lacquer Thinner | |
| Thinning | Use as supplied. But if needed to obtain the desired consistency, add not more than 1/4 Liter of KINGS Epoxy Thinner | |
| Number of coats | 1 – 2 coats | |
| Packaging | Supplied in two separate tin cans | |
| Part A (Resin) Part B (Catalyst) | 4 Liters 3 Liters 1 Liter | |
Surface Preparation
Service life span and the service performance of these products are directly related to the degree of surface preparation
Steel
- The surface must be clean, dry, and free of contamination such as oils, grease, mill scale, or rust.
- A minimum of hand tool cleaning or power tool cleaning is recommended, however commercial blast cleaning will provide
improved performance.
Concrete
- Sweep blast. Remove all contaminants such as dirt and laitance. Acid etched.
Wood
- Block down. Wipe with a cloth containing solvent.
Applications
Stir each component thoroughly before use. Mix to uniform consistency 3 parts of Part A (resin) with 1 part of Part B (Catalyst).
Mixed components should be applied within 6 hours. Surface temperature must be at least 3°C above the dew point to prevent moisture condensation. Note: Ensure protection and proper ventilation if working in contained areas.
| 1st coat | KINGS Epoxy Primer Gray |
| 2nd coat | KINGS Epoxy Enamel Topcoat |
| Final Coat | KINGS Epoxy Enamel Topcoat |
Chemical Resistance
Withstands intermittent splash and spill of aromatic solvents. Resistant to diluted acids and common alkalis and salts.
Consult Bosny Marketing technical representative for certain chemical concentrations and specific services.
Available in different colors:
